Schematic design and the electrical rules check
Now we connect everything. The LED driver's datasheet shows a typical circuit, and we follow it: four LEDs on the driver, 5 V from the USB-C connector, one resistor that sets the LED current, two resistors that make the charger give us 5 V, and capacitors on every power pin.
The big picture
- Datasheets
- Symbols & footprints
- Schematic
- PCB layout
- Files & order
Every part now has a symbol and a footprint. The schematic connects them: it is the electrical plan of the board. Everything in chapter 4 follows from it, because the PCB editor shows each connection we draw here as a line we must route in copper.
Datasheets
- CAT4104VP2-GT3 (onsemi), LED driver · TDFN-8; the datasheet link is on the product page
- 158301265A (Würth Elektronik), white LED 1206 · datasheet and 3D model on the product page
- 10164359-00011LF (Amphenol), USB-C power connector · drawing, pin table and 3D model on the product page
The steps are in the full course
This page shows what the lesson covers. Members get every step with screenshots, the exact values to type, the checks, the fixes and the project files.